(850) 764-6472
[email protected]
[us_page_title description=”1″ font_size=”1.8rem” inline=”1″]

Low-voltage Integrated Wiring Guide For New Construction

If you are building a home, you probably want to plan it for home electronics now, and in the future.

Here are some simple things to consider:

  • Will you want music around the house?
  • Will you have a computer or more than one computer?
  • Will you have TV via antennae, cable, satellite or all of these?
  • Will you want room-to-room control?
  • Will there be adequate access points?
  • Will there be a home theater? With surround sound?
  • Is door cameras with door answering a consideration?
  • Would you prefer one set of controls for lighting, temperature, music, video, etc.?

Lots of decisions to be made. However, these decisions are typically not high on the priority list of a new home owner during the early stages of building a home. Thinking about the modern conveniences of home electronics is sometimes put off until it is too late or at the very least much more costly. If you examine a few of your preferences before the drywall goes up, your electronic “after life” can be a lot more fulfilling.

Pre-wire for today and the Future

Pre Wiring Your New House

Most builders are not electronic specialists. They certainly know more about home construction than about home systems. That is why you will need to be persistent in most cases to get what you want. Many builders focus only on TV and telephone outlets and their placement. Make sure that you are getting all that you need and want, give us a call today! 850.764.6472

TV & Access Points Wiring

TV and access points should be home run to a central location (that is, each wire should terminate at a common central point). This facilitates easier changes in the future and provides the purest signal quality. For access points, ask for data grade, category 6 wiring. This will serve your internet requirements better. For TV, the RG-6 quad shield cabling is superior and carries a higher bandwidth rating as well. Some people often ask about fiber optics. This cable is generally more expensive and competing standards do not necessarily make it a wise choice. With the great number of coax and telephone wired homes, the best bet is CAT6 and RG-6.

The Possibilities

Most people’s home electronics are limited by their knowledge of what is possible. Here are a few thought-provoking possibilities:

 

  • Different Music in Every Room
  • Answer the Door from the Phone
  • Mute Music when Phone or Chimes Ring
  • One Set of Controls…That’s Really Cool
  • Keep an Eye on the House
  • Great Video and Better Sound
  • Share the Home Theater with the Rest of the House

Suggested Wiring & Options

Pre Wiring Your New House

Wiring for a Simply30A smart home is simple and straightforward. Commonly available wiring is used. Simply30AServices commitment to open design gives you many choices for equipment connection. All wires should be home run to a central location (such as a utility closet, entertainment center or similar location). Generally, telephone and TV wiring can be separated from the audio wiring but many homes choose one central location. Here are some simple suggestions:

  1.  Run CAT 6 or better wire for Internet, access points, & telephone lines. This will provide for four lines to each location.
  2.  Run RG-6 Quad Shield coax to all TV and touch panel locations. Dual runs of these wires make future expansion a possibility.
  3. When running audio wires run four conductor (16/4 or better) & Cat-6 through all keypad, volume control and touch-panel locations. This provides the best flexibility in the future. Then run 16/2 to each speaker location.
  4. Run CAT 6 for control wires to each keypad, volume control and touch panel location. This will allow IR and network control of these devices.
  5. Incoming service lead wires will need to be run for telephone, cable, satellite, door speakers and any cameras.
  6. If a computer network such as a LAN is planned, run separate CAT-6 wire for this purpose.
  7. If lighting control is a desired upgrade, most manufacturers have control wires that need to go to the control locations of your choice.
  8. Control wiring for security and HVAC systems, you should consider interface wiring for house wide control systems.